Letux Kernel

Wireless

You are looking at an old revision of the page Wireless. This revision was created by Nikolaus Schaller.

Table of Content

How to configure wireless interfaces (UMTS, WLAN, Bluetooth)

WLAN

is configured as SDIO card "mmc1".

Driver: Marvel 8686 (libertas) Firmware: sd8686.bin

Power and Reset

!!! PRELIMINARY !!!

echo "255" >/sys/class/leds/tca6507:6/brightness # activate reset
echo "2800000" >/sys/devices/platform/reg-virt-consumer.4/max_microvolts
echo "2800000" >/sys/devices/platform/reg-virt-consumer.4/min_microvolts
echo "normal" >/sys/devices/platform/reg-virt-consumer.4/mode
echo "0" >/sys/class/leds/tca6507:6/brightness # release reset

Disable power:

echo "255" >/sys/class/leds/tca6507:6/brightness # activate reset
echo "0" >/sys/devices/platform/reg-virt-consumer.4/max_microvolts

Configure

Driver should be loaded automatically after enabling power. If not, run depmod -a and/or use modprobe. Then:

iwconfig wlan0 
ifconfig wlan0 up
iwlist wlan0 scan

Bluetooth

is accessed through UART1 (/dev/ttyS0).

Enable power

see section WLAN above (power is shared)

Configure

Attach to UART1 as HCI interface

hciattach -n -s 115200 /dev/ttyS0 any 115200 flow & sleep 2
hciconfig -a
hciconfig hci0 up; sleep 2
hciconfig hci0 name GTA04
hcitool dev
hcitool scan

WWAN

is connected to the internal HS-USB. Use lsusb to identify.

Needs Option HSO-kernel driver module.