You are looking at an old revision of the page NewCommands. This revision was created by Nikolaus Schaller.
Table of Content
List of new U-Boot commands
new U-Boot commands
These new commands are available in the Beagle/Panda-Hybrid version of U-Boot. For a listing of all commands, just use the help command of U-Boot.
Indicators:
- status in[it] - setup GPIOs
- status ge[t] - get button status
- status se[t] hh - set LEDs to lower 4 bit
- status se[t] - increment last state, i.e. make LEDs count
- status mi[rror] - read button status and mirror to LEDs until a key is pressed
- status bl[ink] - blink LEDs
- status vi[bra] -255..255 - control vibrator H-bridge
- status fl[ash] - control flash light
Display:
- lcm in[it] - initialize subsystem (DSS, GPIOs etc.)
- lcm fb address - set framebuffer address
- lcm fb 0 - show constant color
- lcm color color - set background color (RRGGBB)
- lcm ba[cklight] dd - set backlight level (0..255)
- lcm po[wer] dd - set power level (0..2)
- lcm on - set lcm on
- lcm of[f] - set lcm off
- lcm st[art] - initialize subsystem, power on LCM and backlight
Touch:
- tsc init - initialize/enable TSC2007 through I2C2
- tsc get - read current ADC values (incl. internal temp and AUX/photosensor)
- tsc lo[op] - read x/y coordinates
- tsc gl[oop] - read all ADCs and draw bars into the framebuffer
- tsc ch[oose] cols rows - defines receptive fields and waits until touch is pressed
- tsc choice x - check if choice was x (1..rows*cols)
GPS:
- gps in[it] - initialize GPS (GPIOs for control and baud rate 9600 on UART2)
- gps on | of[f] - control GPS receiver (and initialize UART)
- gps ec[ho] - read GPS NMEA from UART until a key is pressed
Misc:
- halt - write DEVOFF to TPS65950
- mux - print Pinmux
- gpio - read/write/change GPIOs (must be pinmuxed to mode 4)
- systest - probe peripherals (TPS, I2C etc.)
- systest au[dio] - generate test sound
- systest ch[arge] - enabler battery charger and print mV levels